protocol analyzer 2.0

Post Reply
Nasty76
Posts: 145
Joined: Tue Dec 09, 2014 1:20 am

protocol analyzer 2.0

Post by Nasty76 »

Hi I wonder what I do wrong my USB sound receiver work nethome win and raspi but when try PC protocol analySer that not show nexa commands.
stefangsbb
Site Admin
Posts: 313
Joined: Sun Nov 30, 2014 2:16 pm

Re: protocol analyzer 2.0

Post by stefangsbb »

First check under View->Decoders and see that the protocol is enabled. It could also be the audio settings - Nexa Learning Code protocol has very short pulses, so sometimes the settings has to be very accurate to get it right. Switch on RAW decoding so you can look at the audio signal and hot that is interpreted as digital pulses, there you can perhaps get a hint on where it goes wrong.
Nasty76
Posts: 145
Joined: Tue Dec 09, 2014 1:20 am

Re: protocol analyzer 2.0

Post by Nasty76 »

Weirdest issue is nethome see commands right no problem there. only that protocol analyzer bug when test in windows laptop. and yeah I have select protocls there , that's not big issue but maybe some new user get problems if test that. I was know that earlier but forgot to tell you. I can debug that and change input level my receiver if that help. that was short test to see if my audio receiver work , Linux audio is little hard to config :D
Post Reply