RX433N &

Building and connecting hardware to OpenNethome
Post Reply
PeterS
Posts: 11
Joined: Sun Aug 20, 2017 5:04 am

RX433N &

Post by PeterS »

Has anyone tried the RX433N receiver module and a Raspberrypi like they do at http://www.princetronics.com/how-to-rea ... -receiver/ to receive Nexa 433 MHz signals for NetHomeServer? Looks more simple than using a USB sound card
/Peter S
stefangsbb
Site Admin
Posts: 313
Joined: Sun Nov 30, 2014 2:16 pm

Re: RX433N &

Post by stefangsbb »

I have been working with similar solutions for sending signals, see https://nethomeserver.blogspot.se/search?q=bitbanger. problem is that it is hard to get reliable reception in Linux without a kernel mode driver, which usually means building your own version of the kernal. I am not sure exactly how they do it in this example, but my guess is that the RPI is 100% busy scanning RF, and can do little else.

What I am working with right now however is to use an Arduino as receiver/transmitter. It can handle the real-time parts of reception/transmission and you can find them below $5 on ebay. OpenNetHome has all encoders/decoders built in, so the Arduino only have to receive and send pulses. I think this will be a nice low cost alternative.
PeterS
Posts: 11
Joined: Sun Aug 20, 2017 5:04 am

Re: RX433N &

Post by PeterS »

Sounds great. I'm looking forward to test that :-)

/PeterS
Post Reply