Hi!
I have a Nexa LMDT-810 PIR (rörelsesensor) which runs on battery. When someone walks in front of my door I want to fire an event, send an e-mail, chime a door bell or something along those lines. How do I trigger the event from the PIR in OpenNethome?
(The PIR sensor works by itself because I can pair it with a Nexa plug to light up a lamp.)
Hardware: Raspberry Pi 3 + Tellstick Duo + 433Mhz plugs + PIR sensor
OB1
Nexa PIR sensor to fire an event - how?
-
stefangsbb
- Site Admin
- Posts: 313
- Joined: Sun Nov 30, 2014 2:16 pm
Re: Nexa PIR sensor to fire an event - how?
You use a NexaLCRemapButton to trigger some action when the PIR-sensor fires. You can just go in to the "Create/Edit"-page and then trigger the sensor. You will see it pop up in the "Detected Devices"-window and can create the Item from there.
One thing to watch out for, is that these PIR-sensors keep sending for quite a while when they are triggered, so if you try to trigger some other action on the 433MHz-band as an action, there is a risk that the new transmission is drowned by the PIR-sensor still transmitting.
One thing to watch out for, is that these PIR-sensors keep sending for quite a while when they are triggered, so if you try to trigger some other action on the 433MHz-band as an action, there is a risk that the new transmission is drowned by the PIR-sensor still transmitting.